Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: [email protected] Website: www.integrated-circuit.com
ISPnano Series Programmer - User Manual – V1.11 – 12
th
May 2011
107
3.0 Programmer / ATE Signal routing
3.1 Overview of ports
The
‘ISPnano Series 3 ATE’
programmer features three
‘IDC Ports’
on the back of the programmer
as detailed in the illustration below.
The purpose of each connector is described in the table below.
Connector
name
Description
Connector
type
(1) ‘Target ISP Port’
This port connects to the Target Device (UUT) on the Target
System.
16-way IDC
(2) ‘ATE ISP Port’
This port connects to the external
‘ATE System’
or any other
control electronics which needs to be normally connected to
the Target Device on the Target System.
14-way IDC
(3) ‘Remote Control
Port’
14-way IDC
Instructions:
•
Connect the
‘Target System’
(UUT) to the 16-way
‘Target ISP Port’
.
•
Connect the external
‘ATE System’
or other control system to the
‘ATE ISP Port’
.
•
If you plan to remote control the programmer, connect the relevant remote control signals to
the
‘Remote Control Port’
.
The signal routing depends on whether the relays are energised (ON) or de-energised (OFF) – see
table below.
Relay
position
Relays
ON
Indicator
Signal routing
OFF
(default)
OFF
‘Target ISP Port’
signals are routed to the
‘ATE ISP Port’
ON
ON
‘Target ISP Port’
signals are routed to the
‘Internal Programmer Power
and I/O Driver Circuitry’
(1) TARGET
ISP PORT
(3) REMOTE
CONTROL
PORT
(2) ATE ISP
PORT
124 / 135
124 / 135
