Distributor of Equinox Technologies: Excellent Integrated System Limited
Datasheet of ISPNANO S3 KIT - ISP PORTABLE PROGRAMMER
Contact us: [email protected] Website: www.integrated-circuit.com
ISPnano Series Programmer - User Manual – V1.11 – 12
th
May 2011
83
Appendix 2 – ISPnano Series III (ATE) -
Target ISP Connector Port
1.1 Programmer I/O Signals
The ISPnano Series III / Series III ATE programmers feature the following programmable signal lines
which interface the programmer and the Target IC(s) to be programmed on the Target System:
•
5 x Programmable
Input / Output
lines
•
1 x Programmable
Output only
line
•
1 x 2-wire multi-function port supporting the following interfaces:
o
I2C (Two Wire Interface)
o
Atmel XMEGA 2-wire PDI port
o
Atmel ATtiny 2-wire TPI port
•
1 x Dedicated
RESET
pin
The diagram below shows the available programmer I/O lines:
Please note:
These I/O signals are available on the 16-way IDC Connector labelled
“ISP PORT”
on the ISPnano
Series 1 and 2 programmers and labelled
“Target ISP PORT”
on the
‘Series 3 ATE’
programmer.
100 / 135
100 / 135
