ISPJUNO - Portable ISP Programmer - User Guide V0.84 – 17/04/20
51
3.1 Equinox 10-way Header - AVR SPI Interface
This connection method is suitable for interfacing the programmer to a Target System which features
an 'Equinox 10-way' IDC connector with the Equinox pin-out.
Figure 3.1- Equinox 10-way IDC Header (J7) viewed from above
Warning!
Connecting to the wrong ISP Header may cause
catastrophic damage to the Programmer & Target System
Pin
No
Programmer
Pin name
I/O
Connect to pin on
Target System
Notes
1
TARGET_VCC
P
TARGET_VCC
Target VCC
This pin should be connected to the
Target System Vcc.
2
BUFFER_ENABLE
IO5
Connect to Clock Buffer
circuit Buffer Enable pin
This pin is used to enable the
output of a remote Clock Buffer.
3
Programmer I/O4
IO4 No connect (N/C)
No connection for SPI
4
Programmer I/O1
IO1 SPI – MOSI
5
RELAY ENABLE
O
Controlled output used to
switch external relay
Direct programmer output with 470
ohm resistor in series. Requires
external transistor to drive relay.
6
Programmer I/O2
IO2 SPI – MISO
7 + 9 PROG_GND
P
Signal GROUND (0V)
Signal Ground Connection (1)
0V to which the programmer JTAG,
SPI, I2C signal lines are referenced
to.
8
Programmer I/O3
IO3 SPI - SCK
SPI Clock
10
PROG_RESET/VPP
O
RESET
Target RESET control pin
This pin controls the Target Device
RESET pin.
Key
O - Output from programmer to Target Device
I - Input to programmer from Target Device
P - Passive e.g. GROUND and power rails
N/C - Not connected
