Equinox Systems 2M Flight CasedDMX LED Flame Machine, User Manual, Page: 5 / 8

Operation:
To activate the unit, first connect the IEC cable into the unit and then connect the plug into a AC 240V
power supply. Once the unit has been connected use the “POWER SWITCH” located next to the
“POWER IEC” input socket to turn the unit ON or OFF.
Operating Instructions
The 2M Flight Cased DMX LED Flame Machine is a DMX-512 controllable, full RGBA colour mixing
Flame Machine made up of high efficiency LED’s. There are four colour groups (red, blue, green and
amber) whose intensity can be controlled individually allowing the creation of a range of colours.
The 2M Flight Cased DMX LED Flame Machine will operate in stand-alone, master/slave, sound
activated and DMX-512 control.
Operation modes
Static colour mode
To access the static colour mode, press the “MODE” button to show “C000” on the LED display. Now
press the “ENTER” button to choose “Cr” (red + amber), “C9” (green) or “Cb” (blue). To adjust the
brightness use the “UP” or “DOWN” buttons to increase or decrease the setting from 00-99.
Examples: If you set Cr, C9 and Cb to zero, the LED flame machine will have no LEDs on (blackout).
If you set Cr to 99 and C9 and Cb to zero, the LED flame machine will be 100% Red and Amber.
To add strobe, press the “ENTER” button and use the “UP” or “DOWN” buttons to increase or
decrease the strobe speed from 00-99.
Note: 00 = Off, 99 = Full on
Colour change mode
To access the colour change mode, press the “MODE” button to show “J000” on the LED display. Now
press the “ENTER” button and use the “UP” or “DOWN” buttons to increase or decrease the speed
from 00-99.
Note: 00 = Slow, 99 = Fast
Colour fade mode
To access the colour fade mode, press the “MODE” button to show “F000” on the LED display. Now
press the
“ENTER”
button and use the
“UP”
or
“DOWN”
buttons to increase or decrease the speed
from 00-99.
Note: 00 = Slow, 99 = Fast
Sound active mode
To access the sound active mode, press the “MODE” button to show “Sund” on the LED display. Now
use the “SENSITIVITY” control on the rear panel to adjust the sound sensitivity level.
Master/slave mode
To set the unit as the master, simply use any one of the above modes.
To set the unit as a slave, press the “MODE” button to show “Slau” on the LED display. Now the slave
unit will follow in sequence with the master unit.
Operation