
IM_SGM_07
23
It is recommended that the tool is wiped
down with a clean rag and WD40 or similar
cleaning fluid to remove any dirt or grit
and then liberally greased with a high load
bearing grease (Rocol sapphire high load 2
or similar) in the areas shown.
The tool can now be reassembled by
reversing the dismantling procedure.
Care should be taken to ensure the dowel
protruding from the L/H closed leg of the
tool is engaged between the two centring
springs.
Once the tool is rebuilt, flip the tool over and
repeat the above procedure with the other
side of the tool.
Following the cleaning and lubrication
procedure of the left and right hand sides
of the tool, the actuator can now be
dismantled, cleaned and lubricated as
follows:
Remove the actuator sleeve retaining screw
using a 2.5 mm allen key.
Actuator
Union
Actuator Sleeve
Retaining Screw
Actuator Sleeve
Pull the actuator sleeve back - this will
expose the actuator union retaining circlip.
Expand the circlip with circlip pliers and
slide it up the actuator bolt by about 50 mm
[2"].
SG11TM Only:
Slide the actuator union up the actuator
bolt - this will expose the thrust washers
and thrust race.
Clean the thrust washers and thrust race
with a clean cloth and WD40 (or similar
cleaning fluid) to remove any grit or dirt.
Liberally grease with a high load bearing
grease (Rocol sapphire high load 2 or
similar).
The actuator is reassembled by reversing
the dismantling procedure.
The collet head assembly is dismantled by
following the procedure in Section 5.4. The
various components can then be cleaned
and reassembled.
Actuator
Union Circlip
Actuator
Bolt
Thrust Washer
Thrust Race
Summary of Contents for SG11TM
