QX1000 Manual II: Administrator's Guide
Administrator’s Menus
QX1000; (SW Version 5.3.x)
33
System Contact
text field requires optional information about
the contact person responsible for the SNMP management in
the defined network. Field may indicate the point person’s name,
email address, phone number or other contact information.
Enable SNMP v1 / 2c
checkbox is used to enable SNMP v1/2c
protocol version for the messaging between QX1000’s SNMP
agent and the administrating application. If this checkbox is not
selected,
SNMP v1
will be implied.
SNMP v1 / v2c Read-Only Community
text field is used to
insert the community description (public, private, etc.) for the
read-only management (like gathering information (events,
statistics, etc.) about QX1000’s). Field may contain some kind of
password which should be matching both on QX1000 and on
the administrating application for successful SNMP
management.
Enable SNMP v1 / 2c Read-Write Access
checkbox
additionally enables a read-write access on the QX1000 for the
SNMP monitoring application. With this checkbox enabled,
administrator will be able to remotely configure the QX1000 via
SNMP administrating program.
SNMP v1 / v2c Read-Write Community
text field is used to
insert the community description (public, private, etc.) for the
read-write management (like gathering information (events,
statistics, etc.) about QX1000’s and remotely changing
QX1000’s configuration). Field may contain some kind of
password which should be matching both on QX1000 and on
the administrating application for successful SNMP
management.
Fig. II-51: Global SNMP Settings page
The
Service Restart
button restarts the SNMP sub-system on the QX1000. Restarting the SNMP sub-system is recommended if it does not respond
to a SNMP manager's requests.
SNMP Trap Settings
are used to define the traphosts that
should be informed when certain events occur on the QX1000.
For the listed traphosts to be informed about the events on the
QX1000,
Send SNMP Trap
action should be configured for the
corresponding event(s) from the
page.
SNMP Trap Settings
page contains a list of all configured
traphosts with the referring information.
Fig. II-52: SNMP Trap Settings page
Add
functional button is used to add a new traphost to the table
and opens
Add SNMP Traphost
page where the new traphost
might be defined. Page consists of the following components:
Traphost
text field requires an IP address or the host name of
the traphost. Administrating application’s host address should be
inserted here.
Community
text field requires community description (public,
private, etc.) for the administrating application to accept the
notifications about the certain events on the QX1000. Field may
contain some kind of password which should be the same both
on QX1000 and on the administrating application for successful
SNMP management.
A group of radio buttons is used to select the SNMP protocol
version used for events notifications delivered by the QX1000 to
the administrating application.
Fig. II-53:Add SNMP Traphost page
Diagnostics
The
System Diagnostic
page gives a possibility of running Network protocol diagnostics to verify QX1000's connectivity and to download all system
logs for possible problems recovery.
