QX1000 Manual II: Administrator's Guide
Administrator’s Menus
QX1000; (SW Version 5.3.x)
19
License Status
The
License Status
page displays a table with all available
licenses on the QX1000 and the corresponding settings for each
license (Currently only QCM and DCC license statuses are
displayed).
This page includes the following information:
Type
indicates the type of the license available on the QX1000.
Count
indicates the number of the corresponding licenses
available on the QX1000.
In Use
indicates the number of used licensed from the total
available licenses.
Extension
lists the extensions that are using the corresponding
license. Links in this column move to the corresponding service
configuration page for the extension.
Fig. II-24: License Status page
IP Routing Configuration
Routing
is used to relay information across the Internet from a source to a destination. Along the way, at least one intermediate node is typically
encountered. Routing is different than bridging. The main difference between bridging and routing is that bridging operates at the OSI Data Link
Layer (Level Two Media Access Control Layer) and routing operates at OSI Network Layer (Level Three).
QX1000’s
IP Routing
service allows you to route IP packets from one destination to another (or to a specified router) through QX1000.
The
IP Routing Configuration
page is used to make IP Static and IP Policy routes for IP packets routing. This page consists of three tables. Entries
in the tables are color coded according to the state of the route. For example, yellow indicates disabled routes, green indicates successful routes and
red indicates routes with an error.
IP Static Routes
are used to forward IP packets from the
Network, where the QX1000 is connected, to the specified
destination.
The
IP Static Routes
table displays all established IP static
routes with their parameters:
Target State
for the state of the
route (enabled or disabled),
Actual State
for the state of the route
connection (up, down or erroneous),
Route To
for the subnet
where the incoming packets should be routed to and
Via IP
Address
for the router IP address where incoming packets should
be routed through.
Add
opens the
Add IP Static Route
page where a new static
route can be established.
Enable/Disable
is used to activate and deactivate a selected
route(s). At least one route should be selected in order to use
these functions, otherwise the following error message will
appear: “No record(s) selected.”
Fig. II-25: IP Static Routing table
The
Add IP Static Route
page offers the following components:
Route To
requires the IP address and subnet mask for the
destination the IP packet should be forwarded to.
Via IP Address
requires the IP address of the subsequent router
for IP packet forwarding to the specified destination.
Attention:
The rule with the longest subnet (smallest IP range)
will take effect when having two or more IP Static routing rules
with the coinciding subnets.
Fig. II-26: Add IP Static Routing page
IP Policy Routes
allow IP packets forwarding to the specified router depending on the source IP address as well as defining the priority for the
current routing rule.
