QX5
QXFXO4/QXISDN4/QXE1T1/QXFXS24; (SW Version 6.0.x)
12
QXFXO4/QXISDN4/QXE1T1/QXFXS24 Manual II: Administrator’s Guide
The
Regional Settings and Preferences
are used to select
settings specific to the location of the QX Gateway. This is
important for the functionality of the voice subsystem.
The
Regional Settings and Preferences
page has two drop
down lists to select the
Your Locale (location)
and a
corresponding
Timezone
.
QX Gateway will support Daylight
Savings (DST) correction if it is available for the selected time
zone.
This page also has a manipulation radio button group to choose:
•
System
Language
– selection is available only when the
custom Language Pack has been uploaded and it is used to
enable custom language for system voice messages or
returning back to the default language English.
Fig.II- 5: System Configuration Wizard - Regional Settings page
Internet (WAN) - Internet Configuration Wizard
The
Internet Configuration Wizard
allows the administrator to configure the WAN interface settings and to adjust QX Gateway’s connectivity with an
external network. The
Internet
Configuration Wizard MUST be run for QX Gateway to be connected to the Internet
.
All the settings of the
Internet Configuration Wizard
are
described in the chapters below except those for the IP
settings, which will be described in this chapter.
Attention:
It is strongly recommended not to change the
factory default settings if their meanings are not fully clear
to an administrator.
Fig.II- 6: Internet Configuration Wizard – Getting Started page
The Wizard allows navigating through the following basic configuration parameters and settings:
•
Uplink configuration (see below)
For Protocols
PPPoE
:
•
•
WAN Interface Configuration (see below)
•
For Protocols
PPTP
:
•
WAN IP Configuration (see below)
•
•
WAN Interface Configuration (see below)
•
For Protocols
Ethernet
:
•
WAN IP Configuration (see below)
•
WAN Interface Configuration (see below)
•
