QuadroFXO Manual II: Administrator's Guide
Administrator's Menus
QuadroFXO (SW Version 3.0.x)
54
1. Registration Settings
Primary Server
requires the IP address of the primary Radius
Server.
Secondary Server
requires the IP address of the secondary
Radius Server.
NAT Station IP
text fields require the NAT PC WAN IP address. If
no NAT Station is specified here, Quadro’s IP address will be sent
to the RADIUS server.
Secret Key
is used to insert the secret key between the Radius
client and the server. Contact the Radius server administrator to
get the secret key for your Quadro.
Confirm Secret Key
field is used to verify the secret key. If the
entered
Secret Key
does not correspond to the one in the
Confirm Secret Key
field, the error will appear: “The Secret Key
does not match. Please try again”.
Retry Count
allows selecting the number of attempts before
canceling the registration.
Receive Timeout
allows selecting the timeout (in seconds)
between two attempts to register.
Encoding Type
allows selecting the encoding type (PAP or
CHAP) that should be unique on both the client and the server
sides for the establishment of a successful connection. Encoding
type also should be requested from the Radius Server
administrator.
The
Authorization Port
text field requires the port number on the
RADIUS server where Quadro will send the authentication
requests.
The
Accounting Port
text field requires the port number on the
RADIUS server where Quadro will send the accounting messages.
Fig. II-79: Radius Client Settings page
2. Authentication Settings
The
Username
and
Password
text fields require the user name and password (followed by the password confirmation) used by PSTN callers to
pass the authentication on to the RADIUS Server of the destination Quadro. If these fields are left empty, the original authentication settings that
PSTN users enter into the Quadro Network will be used.
3. Accounting Settings
The
Username
field is dedicated for accounting service only and is used to insert an identification username accounting will be performed on behalf
of. When no username is specified in this field, source username will be used for accounting.
Dial Plan Settings
The
Dial Plan Settings
page is used to adjust the dialing
timeouts for the routing calls over Quadro.
This page consists of the only drop down list used to
configure the dialing timeout for the Routing calls. Values
selected in the lists indicate the interval between the
dialed number and it being applied to the network.
Fig. II-80: Dial Plan Settings page
