LCD screen message
Condition/solution
Combination of IP
There is a problem with the network connection to your product. Check the
address and subnet
solutions in this guide.
mask is invalid.
Recovery mode
An error has occurred during firmware updating. Connect your product using
a USB cable and try updating the firmware again. If you still receive this error
message, contact Epson for support.
Note:
The ink pads in the printer collect, distribute, and contain the ink that is not used on printed pages.
During the life of your product it may reach a condition where either satisfactory print quality cannot be
maintained or the ink pads have reached the end of their usable life. The Epson Status Monitor, your
LCD, or lights on the control panel will advise you when these parts need replacing. If this happens
during the standard warranty of the product, the exchange of the product or replacement of the pads is
covered under the standard warranty. If the product is out of warranty, the pads can be replaced by any
Epson authorized service provider. The waste ink pads are not a user-replaceable part.
Parent topic:
Solving Problems
Related references
Paper Jam Problems Inside the Product
Paper Jam Problems in the Paper Cassette
Paper Jam Problems in the Auto Duplexer
Where to Get Help
Related tasks
Using AirPrint
Selecting the Paper Settings for Each Source - Control Panel
Related topics
Loading Paper
Using Memory Cards With Your Product
Wi-Fi Networking
Running a Product Check
Running a product check helps you determine if your product is operating properly.
1.
Disconnect any interface cables connected to your product.
2.
Load plain paper in the product.
250
Summary of Contents for XP-630
Page 1: ...XP 630 User s Guide ...
Page 2: ......
Page 118: ...You see this window 118 ...
Page 135: ...You see this window 135 ...