6.
When the
power light stops flashing and remains on, you can check to see if the nozzles are
clean; click
Print Nozzle Check Pattern
and click
.
7.
Check the printed pattern to see if there are gaps in the lines.
Print head is clean
Print head needs cleaning
• If there are no gaps, click
Finish
.
• If there are gaps or the pattern is faint, click
Clean
to clean the print head again.
If you don’t see any improvement after cleaning the print head up to 4 times, turn off the product and wait
at least 6 hours. Then try cleaning the print head again. If the quality still does not improve, flush the ink
tubes.
Parent topic:
Related topics
Replacing Ink and Maintenance Boxes
Print Head Alignment
If your printouts become grainy or blurry, you notice misalignment of vertical lines, or you see dark or
light horizontal bands, you may need to align the print head.
Note:
Banding may also occur if your print head nozzles need cleaning.
Aligning the Print Head Using the Product Control Panel
Aligning the Print Head Using the Product Software
Parent topic:
145
Summary of Contents for WF-BM4590
