83
Chapter 5 TM-DT Software System Development
5
Settings - Web service settings - Printer
Performs the settings for printers controlled by TM-DT Software.
You can set the printers when you have set [Enable] under [Device control] in the
tings - Startup settings" on page 82
Settings - Web service settings - Customer Display
Performs the settings for the customer display controlled by TM-DT Software.
You can set the customer display when you have set [Enable] under [Device control] in the
vice settings - Startup settings" on page 82
.
Item
Description
Register printers
Device ID
Set the ID for the controlled printer. (Any character string)
The initial value for the device ID for the printer equipped in this product
is "local_printer".
Type
Select the type for the controlled printer.
Model no.
Select the model number for the controlled printer.
IP address
Set the printer IP address for each device ID.
Retry interval
Set the timeout retry interval.
Add
Adds the printer on this product.
Registered printers
Displays a list of registered printers.
Test printing
Performs a test printing. "TEST_PRINT" is printed.
Delete
Deletes a registered printer.
Item
Description
Do not use
Do not use a customer display.
Use
Use a customer display.
Communication
settings
Communication
speed (bps)
Set the communication speed.
Data bit
Set the data bit.
Parity
Set the parity.
Brightness setting
Set the brightness of the customer display in percentages.
You can set 20%, 40%, 60%, or 100%. The maximum brightness is 100%.
Display test
Check if the customer display operates properly.
When [Display test] is clicked, characters appear on the customer display.
Apply
Registers the settings to this product.
