106
Appendix A Product Specifications
Cut Sheet
Paper type
Check paper (ANSI standard), plain paper (only one sheet can be used)
Size (H × W)
60 to 120 mm × 110 to 235 mm
Paper thickness
0.075 to 0.2 mm
Paper weight
60 to 120 g/m2
•
Use of check paper, OCR paper, or other fine paper is recommended. Use of some paper types
may result in double-feeding by the ASF or other paper feeding problems. It can also lower the
capacity of the pocket.
•
Use flat paper that is not curled or bent (especially the leading edge), curved, wrinkled, or other
problems. Paper that is not flat can jam.
•
Do not insert paper that has clips, staples, or any foreign objects affixed. Doing so can cause paper
jams, MICR reading problems, damage to the MICR head or scanner head, and other problems.
•
Since the paper sensor is a reflective sensor, do not use paper that has holes, that is transparency,
or that has any areas with reflectance less than 40% in the position shown in the illustration below.
However, fanfold paper guide holes with a diameter of 6 mm or less are not detected by the sen-
sor.
55
mm
20
m
m
Area where holes are not allowed and paper reflectance is no less than 40%
Diameter: 6 mm maximum
