Epson TM-S9000
- 7
Buttons
Cleaning button
Pressing this button for three seconds or more starts print head
cleaning.
Note:
Do not clean the print head unless printing becomes faint or
uneven. Unnecessarily cleaning the print head wastes ink.
Feed button
Pressing this button feeds the roll paper.
Setting Up
1. The package should contain the unit, a USB cable, an AC
cable, 2 ink cartridges (SJIC18(K)), the AC adapter, a setup
guide, and a user’s manual.
2. Remove all packing tape, packing foam, and other shipping
materials from the unit.
3. Leave enough room around the product to open the covers,
pull out the ASF tray, and fully extend the pocket(s).
4. Do not place the unit near a magnetic field, such as a display
device. (This reduces the MICR reader accuracy.)
5. Install the unit horizontally (within a tilt of ± 5
°
).
6. Make sure no cords or cables are caught inside the product.
7. Connect the USB cable to the Type B connector on the
product. Attach the cable with the cable harness. (See the
bubble in the illustration below.)
8. Connect the USB cable to the host.
Note:
Do not turn on the unit until you have loaded the necessary
drivers.
9. Connect the AC cable to the AC adapter; then connect the
adapter’s DC cable to the unit’s power supply connector.
10. Insert the AC cable plug into a socket.
Caution:
Use only the specified AC adapter, and never connect
to an improper power source.
11. Turn on the product by pressing the Power button on the
front of the unit. To turn the unit off, hold down the Power
button for 3 seconds, until the Power LED goes off.
Caution:
Be sure the AC cable remains plugged in when powering
the unit off, and always use the Power button.
Loading Roll Paper
Caution:
To avoid injury, do not touch any part of the printer other
than the roll paper when the cover is open.
Note:
Do not open the paper roll cover when the printer is printing
or feeding paper. Only use paper that meets specifications, and do
not use rolls that have the paper glued onto the core.
1. Put your finger under the left side of the roll paper cover
and pull it up to open it.
2. Remove the used roll paper core, if there is one, and insert
the roll paper in the direction shown below.
