Epson tm-m30, Technical Reference Manual

Page: 62 / 120

62
2
After briefly (less than one second) pressing the Feed button once, hold it down for at
least one second, to print the NV graphics information.
After information printing, the Mode selection guidance is printed again.
3
To finish, turn off the power, or select “Exit and Reboot Printer”.
Receipt Enhancement Information Print Mode
You can check the following items using the R/E information mode:
•
Automatic top logo setting
•
Automatic bottom logo setting
•
Extended settings for automatic top/bottom logo
Follow the steps below.
1
After running a self test, hold down the Feed button for at least one second, and then
select the Mode selection.
The Mode selection guidance is printed, and the Paper LED flashes.
2
After briefly (less than one second) pressing the Feed button twice, hold it down for
at least one second, to print the R/E information.
After information printing, the Mode selection guidance is printed again.
3
To finish, turn off the power, or select “Exit and Reboot Printer”.
Software Setting Mode
Set the printer's memory switches and customized values.
•
Print Density
•
Print Speed
•
Enable/Disable Auto Paper Feed&Cut at cover close
•
Embedded Font Replacement
•
Communication condition of USB Interface
•
Buzzer Control
•
Interface Settings
•
Automatic Paper Reduction
•
NV Memory Capacity
•
Command execution during offline
•
LED indicator when I/F starting
•
Paper Width
•
Amount of top margin by backfeed