Epson TM-L90-i, Technical Reference Manual

Page: 63 / 151

Chapter 2 Setup
63
2
Connecting the Cash Drawer
Whe n u s ing a cash drawer, co nn ec t t he cash drawer.
Use t he cash drawer ha n dled by EPSON or yo u r dealer.
Connecting the Drawer Kick-out Cable
Co nn ec t t he co nn ec t or of t he drawer k i ck-o ut cable t o t he pr int er.
WARNING

Specifications of drawers differ depending on makers or models. When you use a
drawer other than specified, make sure its specification meets the following
conditions.

Otherwise, devices may be damaged.

The load, such as a drawer kick-out solenoid, must be connected between pins 4 and
2 or pins 4 and 5 of the drawer kick-out connector.

When the drawer open/close signal is used, a switch must be provided between
drawer kick-out connector pins 3 and 6.

The resistance of the load, such as a drawer kick-out solenoid, must be 24  or more
or the input current must be 1A or less.

Be sure to use the 24V power output on drawer-kick out connector pin 4 for driving the
equipment.

Use a shield cable for the drawer connector cable.

Two driver transistors cannot be energized simultaneously.

Leave intervals longer than 4 times the drawer driving pulse when sending it
continuously.

Be sure to use the printer power supply (connector pin 4) for the drawer power
source.

Do not insert a telephone line into the drawer kick-out connector.

Doing so may damage the telephone line or printer.
DK
24V
Drawer kick-out connector