Adjusting Settings
Follow the steps below to change the settings displayed.
Buttons that are used in the following settings
A
Select an option.
To print at current settings
Press the
d
/
u
buttons to highlight
Keep Settings
Above
and press the
Z
button.
Proceed to Step 6.
To change settings
Press the
d
/
u
buttons to highlight
Change
Settings
and press the
Z
button.
B
Highlight a setting you wish to change and press
the
Z
button.
C
Highlight an option and press the
Z
button.
D
Press the
y
button to return to the dialog shown
in Step 2.
E
When settings are complete, highlight
Exit
and
press the
Z
button.
F
If
On
is selected for
Remaining Setup
, you will
be prompted to enter the length of the roll.
Press the
d
/
u
buttons to choose a value between
5.0 and 999.5m and press the
Z
button. Paper
length is set in increments of 0.5 m.
After a short pause the printer will show
Ready
,
indicating that it is ready to print. Transmit the data to
be printed from a computer.
Replacing Paper
This section describes how to replace paper. The
procedure is displayed on the control panel screen.
Follow these instructions.
Buttons that are used in the following settings
A
Confirm that the printer is ready and press the
(
button.
The Load/Remove Paper menu will be displayed.
B
Press the
d
/
u
buttons to select roll paper, and
then press the
Z
button.
Note:
To perform
Roll Paper Remaining
, you must enter
the length of the roll paper when the roll paper is set.
In order to perform accurate remaining roll paper
management, we recommend opening the
.
tab
and recording the amount of roll paper remaining
when you replace the roll paper.
C
The roll rewinds automatically.
Note:
When the display shows
Turn roll paper adapter
to wind up roll paper.
, rewind the paper by hand.
D
Follow the on-screen instructions to load the roll
paper for the next job.
SC-F6000 Series User’s Guide
Basic Operations
26
