96
Warning:
If ink, waste ink, ink cleaner, or secondary carriage rod grease contact your skin, or get into
your eyes or mouth, immediately do the following:
• Thoroughly wash the substance from your skin with soapy water. If your skin becomes irritated or
discolored, contact a doctor.
• Immediately rinse the substance from your eyes with water to avoid bloodshot eyes or mild
inflammation. If you experience eye problems, contact a doctor.
• If a substance gets in your mouth, contact a doctor immediately.
• If you swallow a substance, do not induce vomiting and contact a doctor immediately. Inducing
vomiting may cause material to get in your windpipe and cause injury.
Caution:
Used cleaning sticks, secondary carriage rod grease, and waste ink are classified as industrial
waste. Dispose of these items according to your local laws and regulations such as entrusting it to an
industrial waste disposal company. When handing over these items to the industrial waste disposal
company, make sure you include the Safety Data Sheet found on Epson's support website.
Parent topic:
Related references
Using Ink Cleaner
Use the ink cleaner and cup that came in the maintenance kit to clean only when instructed to.
Whenever you use the ink cleaner, follow the steps here.
Caution:
Using ink cleaner on any other parts of your product could damage the product.
Be sure to do the following:
• Store ink cleaner at room temperature and out of direct sunlight.
• Use fresh ink cleaner with a fresh cleaning stick each time; do not reuse them.
• Dispose of used cleaning sticks and ink cleaner according to the used parts disposal guidelines; see
the link below.
1.
Place the cup on a tray and pour approximately 0.3 ounce (10 ml) of ink cleaner into the cup.
2.
Recap the ink cleaner bottle.
Summary of Contents for SureColor F9470
