183
If ink, lint, or dust adheres to the areas shown here, clean these areas or parts inside the printer:
• Around the print head
• Wipers
Parent topic:
Solving Print Quality Problems
Related tasks
Cleaning Around the Print Heads
Cleaning the Anti-drying Caps
Overall Print Quality Is Poor
If you notice that your print quality is uneven, too light, too dark, or there are vertical or horizontal lines in
the print (banding), try these solutions:
• Run a nozzle check to see if any of the print head nozzles are clogged. Then clean the print head, if
necessary.
• Align the print head.
• Adjust the media feed. For the most accurate adjustment, print a test pattern using the
Manual >
500mm Pattern
setting. The same media in a different width may require different adjustment values.
• Use genuine Epson ink packs and make sure the ink packs have not expired.
• Raise the temperature of the after heater, and give the after heater and your media time to warm up
before printing again.
• Make sure the media settings in your RIP software are correct for the media you are using.
• Set the
Head Movement
setting to
Printer Full Width
on the product control panel for higher quality
printouts.
• If you are comparing the print result with the image on your computer screen, the colors may not
match. Since monitors and printers produce colors differently, printed colors and screen colors do not
always look the same.
• Make sure that the front cover is closed. Do not open any covers during printing. This can cause the
print head to stop abruptly, resulting in uneven color.
• If you print with 1 or 2 passes in the RIP software, reduce the feed speed in the RIP software.
• Check that the media edge guides are installed correctly and are not damaged.
• If you are using the media settings in the product control panel, set the
Feeding Tension
setting to
Lv1
.
Parent topic:
Summary of Contents for SureColor F9370
