Epson Stylus Pro 10600 - UltraChrome Ink - Stylus Pro 10600 Print Engine, Reference Manual, Page: 93 / 312

-92
Note:
When you are loading very thin paper, set the Suction setting to
WEAKEST
.
16. Press the Enter button to save the selected value.
17. Press the Pause button to exit the SelecType mode.
Selecting the registered settings
To select the registered settings, follow the steps below.
1. In the SelecType mode, press the SelecType button until
PAPER CONFIG MENU
appears on the LCD panel.
2. Press the Item button. You may see
PAPER NUMBER
.
3. Press the + or - button to select the number registered that you
want to use. If you select
STD
, the printer prints data according
to the driver settings. If you select
No. X
, the control panel
settings override the driver settings unless you select
AUTO
in
PAPER THK NO.
. Then press the Enter button.
4. Press the Pause button to exit the SelecType mode.
Printing a status sheet
In SelecType mode, a status sheet can be printed to see the current
SelecType default values.
1. Load paper as described in “Using Roll Paper” or “Using Cut
Sheet Media”.
2. In SelecType mode, press the SelecType button until
TEST
PRINT MENU
is displayed.
3. Press the Item button until
STATUS CHECK
is displayed.