Epson Stylus Photo RX700 Series, Service Manual

Page: 105 / 202

EPSON Stylus Photo RX900 Revision A
Disassembly and Assembly Disassembly and Assembly of Major Parts of Printer 105
4.4.2 I/C Holder Assy
1. Remove the Middle Housing. (p.88)
2. Remove the screw, disengage the hook and remove the Tube Stopper.
(See Figure 4-23)
3. Disengage the hooks (x5) of the Right and Left I/C Holder Assy from the printer
frame.
4. Unhook and remove the Spacer to release the Joint Clamp.
5. Disconnect the tube joints (x2) of the Valve Assy.
6. Remove the screws (x2) securing the Right I/C Holder Assy.
7. Remove the Right I/C Holder Assy while disengaging it from the locating boss, located
inside, and by sliding it toward the front.
8. Remove the screws (x2) securing the Left I/C Holder Assy.
9. Detach all the cables from the left side wall.
10. Remove the Left I/C Holder Assy by shifting it to the left while disengaging it from the
locating boss on the left side first and then by sliding it toward the front.
11. Remove the I/C Holder Assy from the printer.
Figure 4-37. Removing the I/C Holder Assy
C A U T I O N
„
In this process, there is a possibility of ink leakage. Take great
care not to stain any surrounding objects with ink.
„
Take care during work not to damage any tube.
„
Refer to the following section for the connection of the I/C
Holder Assy and the Valve Assy (including Ink Tube Assy):
•
Connection of Valve Assy and I/C Holder Assy (p.95)
„
Route the power cable as shown at right.
Tube Spacer
Tube Guide Ground Plate
I/C Holder Assy
Torque: 0.6 ± 0.1N
⋅
m
Torque: 0.6 ± 0.1N
⋅
m
C.B.P-Tite 3x8 F/ZN-3C
Tube Stopper
Spacer
Joint Clamp
C.B.P-Tite 3x8 F/ZN-3C(x4)
Disengage the cam, if
engaged with, from the
aperture of the I/C
Holder Assy.
Detach the
cables
Unhook
Release the clamp
Boss
Hook
Pressure Tube C
Routing of power
harness