Making Prints From Slides or Negatives
21
Placing 35-mm Film Strips in the Holder
1. Remove the film strip cover.
2. Slide your film strip into the holder.
Note:
The photos should be mirror-imaged when viewed from overhead. (The shinier
side of the film faces down; the duller side faces up.)
3. Replace the film strip cover.
4. Fit the holder’s tabs into the two small holes at the rear edge of the glass.
Make sure the film strip is in the middle of the glass (not at the rear edge) to
align it with the fluorescent lamp when you close the lid.
Continue with the steps in the next section to scan and print your photos.
Film strip is in
middle of glass
Fluorescent lamp
Summary of Contents for Stylus Photo RX700 Series
Page 1: ...RX700 ALL IN ONE PHOTO CENTER ALL IN ONE PHOTO CENTER Basics ...
Page 6: ...6 Contents ...
Page 60: ...60 Printing on CDs and DVDs ...
Page 92: ...92 Notices ...