❑
The paper was exposed to excess humidity, over 60%. See
Appendix A for specifications on required environmental
conditions.
❑
The edge guides are too tight or too loose. Adjust the left
edge guide for the size of the paper.
❑
Too many sheets are loaded in the sheet feeder. You can
load up to 100 sheets of plain paper, 70 sheets of special
coated paper, 10 envelopes, 50 sheets of transparency film
(with one sheet of plain paper beneath the stack), or 30
sheets of high-quality glossy paper (with one sheet of plain
paper beneath the stack).
Other Paper Handling Problems
If you have other paper handling problems, see the following
suggestions.
The printer loads more than one sheet at a time.
Remove the stack of paper and fan it. Tap it on a flat surface to
even the edges. Then reload the paper.
The paper is too thin or thick, or was exposed to excess
humidity; see Appendix A for exact specifications.
Make sure the paper thickness and thickness adjustment levers
are set correctly for your media type; see Chapter 1 for
instructions.
Make sure the printer driver’s
Copies
setting and the copies
setting in your application software are set to print one copy at
a time. Also verify that you have selected the correct paper size
in the driver and in your application software.
R
Hudson User’s Guide
A5 size
Chapter 4
10-28-95
DR, pass 2-Rev1
Troubleshooting
4-13
