Epson Stylus C82WN, Setup And Installation Manual

Page: 24 / 72

20
Configuring Wireless Printing for Windows
8. Check the following information on the status page:
■
Note the WiFi Channel and Mode, and the Actual SSID. If the SSID does
not match your network, your print server may be picking up signals from
somewhere else. You can correct this when you configure the print server.
■ Under NETWORK STATISTICS, make sure you see numbers indicating
that the print server has received and transmitted data. If only zeroes appear,
your print server may not be working correctly. Try holding down the print
server’s test button for at least five seconds to reset it
.
If it is still not working,
contact EPSON as described on page 52.
9. Continue with the following instructions to configure the print server.
Configuring the Print Server
After your print server is set up and plugged in, you’re ready to configure it for your
network.
1. On the Wireless Server Search screen click
START.
WP-Admin picks up the signal from the print server and displays information like
the following:
Note: If WP-Admin fails to pick up a signal from the print server, try holding down
the print server’s test button for at least five seconds to reset it. The lights go out,
then both the green and yellow lights come on briefly. The yellow light remains
on when your network has a connection to the print server.
If it still fails to pick up a signal, check the solutions beginning on page 44.
This information
appears when the
server is found
This number
indicates the
signal strength
c82WN.book Page 20 Thursday, January 16, 2003 2:47 PM