R4CE770 SETUP_UK1
Rev.C
SETUP.FM
A2 size
3/29/04
Proof Sign-off:
N.Yoshie CRE Kawakami
K.Yoda
editor
Unpacking
Unpacking
Unpacking
Unpacking
1. Remove the contents from the box. Remove all tape and
packing material from the printer.
c
Caution:
Be sure not to touch the ribbon cable inside the printer.
2. Attach the paper support and plug in the printer.
Installing the Ink Cartridges
Installing the Ink Cartridges
Installing the Ink Cartridges
Installing the Ink Cartridges
1. Press the
P
power button to turn on the printer.
2. Remove the ink cartridges from their protective bags.
3. Install the ink cartridges as shown below.
Note:
Install all ink cartridges. The printer will not work unless all cartridges are installed properly.
4. Press the
(
Maintenance button.
The printer begins ink charging. It takes about
one and a half minutes
. While charging, the printer produces a variety of mechanical sounds. This is normal.
When the green light stops flashing, ink charging is complete.
c
Caution:
Do not turn off the printer during the ink charging process.
Note:
The ink cartridges packaged with your printer are partly used during initial setup. In order to
produce high quality printouts, the print head in your printer will be fully charged with ink. This
one-off process consumes a quantity of ink and subsequent cartridge sets will last for their full
rated life.
The contents may vary in certain locations.
The power cord comes attached in some
countries.
Setup
printer
ink cartridges
paper support
power cord
CD-ROM
All rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any form or by any means, electronic, mechanical, photocopying, recording, or otherwise, without the prior written permission
of Seiko Epson Corporation. The information contained herein is designed only for use with this Epson printer. Epson is not responsible for any use of this information as applied to other printers. Neither Seiko Epson Corporation nor its affiliates
shall be liable to the purchaser of this product or third parties for damages, losses, costs, or expenses incurred by the purchaser or third parties as a result of: accident, misuse, or abuse of this product or unauthorized modifications, repairs,
or alterations to this product, or (excluding the U.S.) failure to strictly comply with Seiko Epson Corporation's operating and maintenance instructions.
Seiko Epson Corporation shall not be liable for any damages or problems arising from the use of any options or any consumable products other than those designated as Original Epson Products or Epson Approved Products by Seiko
Epson Corporation. Seiko Epson Corporation shall not be held liable for any damage resulting from electromagnetic interference that occurs from the use of any interface cables other than those designated as Epson Approved Products
by Seiko Epson Corporation. EPSON is a registered trademark and EPSON Stylus is a trademark of Seiko Epson Corporation.
Copyright 2001 Seiko Epson Corporation. All rights reserved. PRINT Image Matching is a trademark of Seiko Epson Corporation. The PRINT Image Matching logo is a trademark of Seiko Epson Corporation.
Microsoft and Windows are registered trademarks of Microsoft Corporation.
General Notice:
Other product names used herein are for identification purposes only and may be trademarks of their respective owners. Epson disclaims any and all rights in those marks.
Do not remove or tear the label on the cartridge.
Do not touch this part.
Installing the Printer Software
Installing the Printer Software
Installing the Printer Software
Installing the Printer Software
1. Press the
P
power button to
turn off the printer. The green
light goes off.
2. Connect the printer and computer with a USB cable, then
insert the printer software CD into the CD-ROM drive.
3. Install the printer software.
Select your country or area of residence if the selection window
appears. Then except where otherwise instructed, click or
double-click the areas circled in red to proceed.
c
Caution:
Turn off all virus protection programs before installing the printer
software.
Note:
If the language selection window appears, select your preferred
language.
After installation is complete, see the
Reference Guide
for
detailed information about printing from your computer for the
first time.
The CD-ROM includes EPSON PhotoQuicker, EPSON PhotoStarter, EPSON
CardMonitor, EPSON PRINT Image Framer Tool, PIF DESIGNER, and EPSON
Web-To-Page.
EPSON PhotoQuicker is a fun and easy to use program with a number of
features that help you create outstanding photos.
For more details, double-click the
ESC46 Software Guide
icon on the desktop
to view
Photo Print Software Setup
.
Loading Paper
Loading Paper
Loading Paper
Loading Paper
Note:
To adjust the left edge guide, hold down the locking tab and slide the guide against the paper stack.
Viewing the Reference Guide
Viewing the Reference Guide
Viewing the Reference Guide
Viewing the Reference Guide
The
Reference Guide
provides detailed information about printing from a computer, printer maintenance, problem solving, and safety.
To view the
Reference Guide
, double-click the
ESC46 Reference Guide
icon on the desktop.
You can also access the
Reference Guide
via the Start menu. To do so, click
Start
, point to
All Programs
in Windows XP or
Programs
in Windows Me, 98, or 2000,
point to
EPSON
, then select
ESC46 Reference Guide
.
Safety Instructions
Read all of the instructions in this section when setting up and using your printer.
When choosing a place for the printer
❏
Avoid places subject to rapid changes in temperature and humidity. Also, keep the printer away from direct
sunlight, strong light, or heat sources.
❏
Avoid places subject to dust, shocks, or vibrations.
❏
Leave enough room around the printer to allow for sufficient ventilation.
❏
Place the printer near a wall outlet where the plug can be easily unplugged.
❏
Place the printer on a flat, stable surface that extends beyond the base of the printer in all directions. If you
place the printer by the wall, leave more than 10 cm between the back of the printer and the wall. The printer
will not operate properly if it is tilted at an angle.
❏
When storing or transporting the printer, do not tilt it, stand it on its side, or turn it upside down. Otherwise ink
may leak from the cartridge.
When choosing a power source
❏
Use only the type of power source indicated on the printer’s label.
❏
Use only the power cord that comes with this product. Use of another cord may result in fire or electric shock.
❏
This product’s power cord is for use with this product only. Use with other equipment may result in fire or electric
shock.
❏
Be sure your AC power cord meets the relevant local safety standard.
❏
Do not use a damaged or frayed power cord.
❏
If you use an extension cord with the printer, make sure that the total ampere rating of the devices plugged
into the extension cord does not exceed the cord’s ampere rating. Also, make sure that the total ampere rating
of all devices plugged into the wall outlet does not exceed the wall outlet’s ampere rating.
❏
If you plan to use the printer in Germany, the building installation must be protected by a 10 or 16 amp circuit
breaker to provide adequate short-circuit protection and over-current protection for this printer.
When handling ink cartridges
❏
Keep ink cartridges out of the reach of children. Do not allow children to drink from or otherwise handle the
cartridges.
❏
Do not open the ink cartridge packages until just before you install them.
❏
Do not shake the ink cartridges; this can cause leakage.
❏
Be careful when you handle used ink cartridges, as there may be some ink remaining around the ink supply
port. If ink gets on your skin, wash the area thoroughly with soap and water. If ink gets into your eyes, flush them
immediately with water. If discomfort or vision problems remain after a thorough flushing, see a doctor
immediately.
❏
You must remove the yellow tape seals from the cartridges before installing them; otherwise, the cartridges will
become unusable.
❏
Do not remove the blue portion of the tape seal from the top of the cartridges.
❏
Do not remove the tape seals from the bottom of the cartridges.
❏
The IC chip on this ink cartridge retains a variety of cartridge related-information, such as the amount of ink
remaining, so that a cartridge may be removed and reinserted freely. However, each time the cartridge is
inserted, some ink is consumed because the printer automatically performs a reliability check.
❏
Do not touch the green IC chip on the side of the cartridge.
When using the printer
❏
Do not put your hand inside the printer or touch the ink cartridges during printing.
❏
Do not block or cover the vents and openings in the printer.
❏
Do not attempt to service the printer yourself.
❏
Unplug the printer and refer servicing to qualified service personnel under the following conditions: The power
cord or plug is damaged; liquid has entered the printer; the printer has been dropped or the casing damaged;
the printer does not operate normally or exhibits a distinct change in performance.
❏
Do not insert objects through the slots in the printer.
❏
Take care not to spill liquid on the printer.
❏
Leave the ink cartridges installed. Removing the cartridges can dehydrate the print head and may prevent the
printer from printing.
Information for United Kingdom Users
Use of options
EPSON (UK) Limited shall not be liable against any damages or problems arising from the use of any options or
consumable products other than those designated as Original EPSON Products or EPSON Approved Products by
EPSON (UK) Limited.
Safety information
w
Warning:
Refer to the rating plate for the voltage and check that the appliance voltage corresponds to the supply
voltage.
Important:
The wires in the mains lead fitted to this appliance are coloured in accordance with the following
code:
Blue — Neutral
Brown — Live
If you have to fit a plug:
As the colours of the mains lead of this appliance may not match the coloured markings used to identify the terminals
in a plug, please observe the following:
❏
The blue wire must be connected to the terminal in the plug marked with the letter N.
❏
The brown wire must be connected to the terminal in the plug marked with the letter L.
❏
If the plug is damaged, replace the cord set or consult a qualified electrician.
❏
Replace fuses only with fuses of the correct size and rating.
Follow the on-screen instructions.
If the installer dialog box does not appear,
double-click
EPSETUP.EXE
on the CD-ROM.
left edge guide
output tray extension
locking tab
Setup
Color Ink Jet Printer
English
4049573-00
xxx
c
Cautions
must be observed to avoid
damage to your equipment.
Notes
contain important information and
useful tips on the operation of your printer.
Warnings, Cautions and Notes
w
Warnings
must be followed carefully to
avoid bodily injury.
4049573
Rev.0
1-F
BK
4049573
Rev.0
1-F
Y
4049573
Rev.0
1-F
M
4049573
Rev.0
1-F
C
4049573
Rev.0
1-F
BK2
Veuillez trouver les instructions en français au verso.
