Note:
You can also confirm differences in tension by
tapping both edges of the media as shown in the
illustration below.
F
Hold down the
d
button until the edges of the
media are taken up and wrap around the core
once or twice.
Take-up with the Printed Side
Facing Out
A
While pulling the center section of the media
straight down, affix the media to the take-up roll
core with commercially available adhesive tape.
c
Important:
Attach the media to the take-up roll core with
the media pulled tightly. If media is attached
loosely, the media may move around during
take-up.
B
Hold down the
d
button in the control panel to
feed enough media for a single wrap around the
take-up roll core.
SC-F9400H Series/SC-F9400 Series Operator's Guide
Basic Operations
21
