Epson S1S65010, Technical Manual

Page: 8 / 40

1. OVERVIEW
S1S65010
EPSON
1
Evaluation Board Technical Manual (Rev. 1.1e)
1. OVERVIEW
This product, the S1S65010 Evaluation Board Kit, is for quickly building a network-accessible camera based on the
Seiko Epson S1S65010 network camera chip. It consists of two main components: a main board (Product Number
S5U1S65K01H0100) containing the S1S65010 and other major ICs and a camera board (Product Number
S5U1S65K01H1100) for mounting a camera module.
2. COMPONENTS
2.1. Main Board (Product Number S5U1S65K01H0100)
Network camera IC: S1S65010
Flash EEPROM: 4 MB (Toshiba TC58FVM5B2ATG65)
SRAM: 2 MB (Toshiba TC55VBM416AFTN)
SDRAM: 16 MB (Micron MT48LC8M16A2TG-75)
Ethernet interface: Support 10/100BaseT via MII
RJ45 connector
↔ TG110-LC55NC ↔ ICS1893BF
JTAG debugging interface: 20-pin connector for in-circuit emulator or other debugger
Camera board interface: 16/40-pin connector for camera board
I
2
C: Part of the camera board interface connector is used for camera control.
It is also connected to a serial EEPROM (BR24L56RFVM-W).
I
2
S: Part of the camera board interface connector is used for connecting a
monaural codec IC.
GPIO: Part of the camera board interface connector is used for evaluating
GPIO operation.
Serial interface: 10-pin RS232-C connector
Power supply voltage: 5 V
±
10%
2.2. Camera Board (Product Number S5U1S65K01H1100)
This board provides connectors for the following three CMOS camera modules.
•
OmniVision OV7640 EAA (or OV7648 EAA)
•
Hynix HV7131GP (HYCA3-L01)
•
Fuji Film Microdevices SA2101A
Note: This board does not support simultaneous connection of multiple camera modules. The
developer must pick one of the above three.
This board includes a monaural codec IC, an AK4536 with built-in microphone and speaker amplifiers.