Epson RX595 - Stylus Photo Color Inkjet, Service Manual, Page: 107 / 131

EPSON Stylus Photo RX585/RX595/RX610 Revision B
Adjustment Banding Reduction System (BRS) Adjustment/Paper Feed Amount Profile (PFP) Correction 107
5.3 Banding Reduction System (BRS) Adjustment/
Paper Feed Amount Profile (PFP) Correction
5.3.1 Overview
This section explains how to carry out BRS/PFP adjustments.
† Tools and paper required to perform the adjustment
† Specified Scanner to perform the adjustment
The following are the scanners that can be used for scanning the pattern in BRS/PFP
adjustment. When starting up the adjustment program, select the scanner to use.
Figure 5-11. System Configuration
C H E C K
P O I N T
„ For overview of BRS/PFP Adjustment, refer to Chapter 2 “2.3
Banding Reduction System (BRS)/ Paper Feed Profile Correction
(PFP)
(p.38)
„ Be sure to have a specified scanner ready beforehand as it is
necessary to carry out the adjustment. Before scanning,
confirm that the document table is free from any dirt or stain.
Table 5-6. Tools and Paper for BRS/PFP Adjustment
Tools/Paper Product Code
Common PFP Base scale 1453980
BRS
Matte Paper-Heavyweight
(A4)
---
PFP
Premium Glossy Photo Paper
(4 x 6)
---
C A U T I O N
„ Install the driver of the scanner to the PC in advance.
„ As the profile required for the adjustment is not prepared for
scanners other than the ones specified below, BRS/PFP
Adjustment can not be carried out by the other scanners.
Table 5-7. Specified Scanner for BRS/PFP Adjustment
Model Name Sensor type Remarks
Perfection 4990 Photo CCD
Perfection V700 Photo CCD
Stylus Photo RX560/RX580/RX590 CIS Use the internal scanner.
Stylus Photo RX585/RX595/RX610 CIS Use the internal scanner.
Stylus Photo RX680/RX685/RX690 CIS Use the internal scanner.
C H E C K
P O I N T
Depending on the sensor type of the scanner to use for the
adjustment, drying time required after the BRS adjustment
pattern has been printed differs. For PFP adjustment pattern/PFP
check pattern, drying time is not required.
„ For “CCD” sensor:
Printed pattern can be scanned straight away. (Drying time of
about 2 minutes is recommended.)
„ For “CIS” sensor:
Printed pattern needs to be dried more than 5 minutes.
Calculate
correction
value
Test Pattern Scanner PC Printer