42
Related tasks
Connecting to External Speakers
Connecting to an HDBaseT Transmitter
To send an HDMI or RS-232C signal over a long distance, you can connect the projector to an optional
HDBaseT transmitter using a 100Base-TX network cable. This is useful when you want to send a signal
to or control the projector from a remote location, such as in a hall or event site, since you can use a
network cable up to 328 feet (100 m) in length. To ensure proper data transmission, use a Category 5e
STP cable or better.
1.
Turn off the projector and HDBaseT transmitter.
Note:
Make sure the projector and HDBaseT transmitter are turned off when connecting or
disconnecting a network cable between the two devices.
2.
Connect one end of the network cable to the
HDBaseT
port on the transmitter.
3.
Connect the other end to the projector's
HDBaseT
port.
Note:
See the documentation that came with the HDBaseT transmitter for instructions on connecting
it to your video device or computer.
4.
Turn on the projector and HDBaseT transmitter.
Note:
To enable communication from the Ethernet and serial ports on the transmitter, select
On
as the
Control Communications
setting in the projector's Extended menu. Turning on this setting disables the
projector's
LAN
,
RS-232C
, and
Remote
ports. If you connected an Extron XTP transmitter or switcher to
the projector's
HDBaseT
port, select
On
as the
Extron XTP
setting in the projector's Extended menu.
Parent topic:
Summary of Contents for Pro L1500UH
