195
•
Full Display
to adjust the image to the projector's screen size as you scale the image
7.
If you selected
Auto
as the Scale setting, you can skip the remaining steps. If you selected
Manual
,
adjust each of the following options as necessary:
•
–
or
+
to scale the image horizontally and vertically at the same time
•
Scale Vertically
to scale the image vertically only
•
Scale Horizontally
to scale the image horizontally only
8.
Select the
Clip Adjustment
setting and use the arrow buttons to adjust the coordinates and size of
each image as you view the screen.
9.
When you are finished, press the
Menu
button.
Parent topic:
Enabling Protocol Emulation
You can use protocol emulation to control your projector with the same RS-232 control codes as those
used by the manufacturers of other projectors. This lets you control a group of projectors from a common
controller.
1.
Make sure the projector is turned on.
2.
Connect a controller to the RS-232C port on the projector.
3.
Do one of the following:
• Press and hold the
Test Pattern
button on the remote control for at least five seconds.
• Select the
Extended
menu, highlight the
Standby Mode
setting, and hold down the right arrow
button on the remote control or projector control panel for at least five seconds.
Summary of Contents for Pro L1500UH
