113
ELPLX01/ELPLX01W ultra short-throw lens
1
Center of lens
2
Projected image when lens shift is set to the home position
3
Maximum range: V × 17%
4.
When you are finished, press the
Esc
button on the control panel or remote control.
Note:
When adjusting the image height, position the image lower than where you want it to be and then
move it up. This will help prevent the image from moving down after adjustment. The image is clearest
when the lens is at the home position. To move the lens to the home position, press and hold the
Lens
Shift
button on the remote control or the
Lens
button on the control panel for at least three seconds.
Parent topic:
Using Basic Projector Features
Adjusting the Image Position Using Screen Position
You can adjust the image position if there are margins between the edge of the image and the projected
screen frame.
Note:
You cannot adjust the screen position if the
Screen Type
setting is set to
16:10
for a WUXGA
projector model or
4:3
for a XGA projector model.
1.
Turn on the projector and display an image.
2.
Press the
Menu
button.
3.
Select the
Extended
menu and press
Enter
.
Summary of Contents for Pro L1060U
