40
4.
Turn on the projector and HDBaseT transmitter.
Note:
To enable communication from the Ethernet and serial ports on the transmitter, select
On
as the
Control Communications
setting in the projector's Extended menu. Turning on this setting disables the
projector's
LAN
and
RS-232C
ports. If you connected an Extron XTP transmitter or switcher to the
projector's
HDBaseT
port, select
On
as the
Extron XTP
setting in the projector's Extended menu.
Parent topic:
Related references
Projector Setup Settings - Extended Menu
Connecting to an External Computer Monitor
If you connected a computer to the projector's
Computer
port, you can also connect an external monitor
to the projector. This lets you see your presentation on the external monitor even when the projected
image is not visible.
To output images to an external VGA monitor, set the
Monitor Out Port
setting to
Monitor Out
in the
projector's Extended menu.
If you want to output images to an external monitor when the projector is turned off, you need to select
Always On
as the
A/V Output
setting in the projector's Extended menu.
Note:
Monitors that use a refresh rate less than 60 Hz may not be able to display images correctly.
1.
Make sure your computer is connected to the projector's
Computer1
port. If there are two computer
ports, make sure you use the
Computer1
port.
2.
Connect the external monitor's cable to your projector's
Monitor Out
port.
Summary of Contents for PowerLite EB-L520W
Page 1: ...PowerLite EB L520W User s Guide ...
Page 2: ......
Page 10: ......
Page 27: ...27 Front Rear Front ceiling ...
