Epson PowerLite 84, User Manual

Page: 58 / 123

58
Using the Projector on a Network
Using Projector E-mail Alerts
When this feature is enabled, the projector sends you an e-mail alert if
it has any problems.
1. Press the
Menu
button on the remote control, select the
Network
menu, then press
Enter
.
2. Choose
Network Configuration
and press
Enter
.
3. Choose
Mail
, then press
Enter
. You see the following screen:
4. Highlight
On
to receive email notifications, then press
Enter
.
5. Enter the IP address for the SMTP server for the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following IP addresses cannot be used: 127.x.x.x,
224.0.0.0 to 255.255.255.255 (where x is a number from 0 to
255).
6. Enter the SMTP server’s port number. The default value is 25.
You can enter a numeric value from 1 to 65535.
7. Choose one of the
Address
fields, then enter the e-mail address
and the contents of the message that you will receive when a
problem or warning occurs. You can register up to three addresses.
You can enter up to 32 alphanumeric characters for the e-mail
address.
note
If a critical problem develops
with a projector which
causes it to suddenly stop
working, it may not be
possible for the projector to
send a message.
If Standby Mode is set to
Communication ON in the
Extended menu, the
projector can still be
monitored even if the
projector is in standby mode
(when the power is off).