EPSON
®
PowerLite
®
8200i /9100i
Quick Setup
Connect the power cord to your projector and plug the other end into a grounded outlet.
3
Connect the other end to your laptop’s video or
monitor port. If you can’t connect the cable
to your PowerBook
®
, you may need to use an adapter. See your User’s Guide for instructions.
2
Press the red Power button on the projector to turn it on.
The
power light flashes green as the projector warms up,
and the projection lamp comes on in about 30 seconds.
3
Turn on or restart your laptop. (Windows
®
only: If you see
this Add New Hardware screen, click Cancel.)
Turn over
To shut the projector down properly, press the red Power button twice. Let the
projector cool while the
power light flashes orange (about a minute). Once the light
stops flashing and stays on, it’s safe to unplug the projector.
Never unplug the projector when the
power light is green or flashing orange.
Locate everything
you’ll need
Plug in your projector
Turn on your equipment
Caution:
Before unplugging the projector...
For most setups, you’ll need just these two cables:
You won’t need to install any software.
1
2
Make sure your projector and laptop are turned off.
Connect one end of the computer video cable to the
Computer 1 (VGA) port on the projector.
Connect the projector
to your laptop
power cord
computer video cable
Follow these instructions to connect the projector to your laptop.
To connect other devices – such as a VCR or desktop PC – and to
use the remote control, see your User’s Guide.
power light
power button
1
Remove the lens cap.
8291iPoster.qx 12/14/01 9:31 AM Page 1
