14
Preparing to Print
Note:
For best results, allow your prints to dry thoroughly for
24 hours before framing.
Inserting a Memory Card
1.
Press the
d
On
button to turn on PictureMate.
2.
Make sure the memory card light is off and no
cards are in both slots. Then insert a memory card
into the correct slot, as shown in the illustration.
c
Caution:
❏
Insert just one card at a time.
❏
Load your memory card only as shown
in the table below or you may damage
your printer, memory card, or both. If
you insert a card incorrectly, you see
an error message on the LCD screen.
Remove the memory card and insert it
correctly.
❏
Do not press the button on the right
side of the lower card slot when you
insert a CompactFlash card or you
cannot remove the card.
❏
If the CompactFlash card is not
recognized, remove the card and
insert it again.
