Epson PhotoPC 2100Z, Service Manual

Page: 67 / 108

PhotoPC 2100Z Revision E
Adjustment Tools 61
5.2 Tools
5.2.1 Tools
The table below lists the tools needed for adjustments of PhotoPC 2100Z.
5.2.2 Adjustment Programs
The adjustment items require the respective adjustment programs. For use, register
adjustment programs in CF cards, respectively.
Table below shows the adjustment items and files.
Table 5-2. Adjusting Tools
Adjustment Items Tool Tool Code
BC adjustment Battery Tool 1091789
LCD adjustment RS-232C I/F 1091792
RS-232C cable 1091790
LCD adjustment / USB ID writing
Serial
cable
1104424
CCD gain adjustment, shutter
compensation and black defect input
& white defective compensation Color viewer 1030584
Strobo adjustment Strobo adjust chart 1091791
AF adjustment AF adjustment chart Attached at the end of
this manual
Table 5-3. Adjustment Programs
Adjustment Item File Name
“BC (Battery Check) Compensation Value Writing” BC.c21
“LCD (Brightness) Adjustment”
1. CRT21ma.exe
2. LCD.c21
“CCD Gain Adjustment, Shutter Compensation Black
Defect Writing and White defect compensation”, CCD.c21
“Strobo Adjustment” Strobe.c21
“AF (Auto Focus) Compensation” AF.c21
“USB ID Writing”
1. CRT21sp.exe
2. USB.c21
C A U T I O N
„
The PC to be used must be of a model which permits use of the
USB interface on Windows 98 or a later operating system.
„
Only one program file must be stored in one CF card if the file
name has an extension “c21”. If two or more program files with
an extension “c21” are stored in one CF card, proper selection
of the program to be executed by the camera will not be
ensured.
„
When storing a program in a CF card, pay attention to the
property of the file. If the property is “read only”, the camera
can not execute the program. And, check a mark on the archive
check box in the property, otherwise the camera can not
execute it too.
„
When all the adjustments to be made, perform “BC (Battery
Check) Compensation Values Writing” first. The other
adjustments can be performed in any sequence. These
adjustments include the initialization of the adjusted value
storage area in the camera.
„
Once “BC (Battery Check) Compensation Values Writing” is
performed, be sure to perform all the other adjustments
subsequently, without omitting any of them.
„
Once any error occurs during execution of an adjustment,
perform the same adjustment again under the same conditions.
(See "Explanation of Error Codes" on page 62)
„
If an error recurs, check for proper conditions under which the
adjustment is performed.
„
When performing any of the CCD adjustment, AF adjustment
and Strobo adjust, make sure that the lens cover is open.