89
n
= on,
f
= flashing
•••
= short series of beeps (three beeps)
•••••
= long series of beeps (five beeps)
Note:
The printer beeps once if you press a control panel button when the
corresponding function is not available.
Problems and Solutions
Most problems you may encounter while operating your printer
have simple solutions.
You can check the operation of your printer using the self test. See
“Printing a Self Test”. If the self test works properly the problem
probably lies in the computer, the application software, or the
interface cable. If the self test does not work, contact your dealer
or a qualified service person for assistance.
Note:
If you are an experienced user or a programmer, you can print a
hexadecimal dump to isolate communication problems between the
printer and computer. To print a hex dump, turn off the printer. Next,
hold down the
Load/Eject
and
LF/FF
buttons while you turn on the
printer. Then send data from your computer. The printer prints all the
codes it receives in hexadecimal format.
f
All the lights on
the control
panel
•••••
An unknown printer error has occurred.
Turn off the printer and leave it off for
several minutes; then turn on the printer
again. If the error recurs, contact your
dealer.
Panel light
state
Beep
pattern
Problem
Solution
Summary of Contents for LX-1170+II
Page 1: ...User s Guide NPDxxxx 00 ...
Page 13: ...13 Glossary Index ...
