Note:
The cards can be loaded only in the front or rear paper slot.
Before loading cards, set the paper-thickness lever to position 2 and set the paper release lever to the
single-sheet position.
To load a single card, follow the instructions in “Loading paper in the rear sheet guide” on page 47.
Note:
❏
When you are loading postcards long edge first, always load them in the rear slot.
❏
Before printing, turn on the card mode by pressing the
Tear Off/Bin
button several times until the left
Tear Off/Bin
light is on.
❏
Use postcards under the following temperature and humidity conditions:
Temperature: 15 to 25 ˚C (59 to 77 ˚F)
Humidity: 30 to 60% RH
❏
When loading A6 size cards, always load them long edge first.
Switching Between Continuous Paper and Single Sheets
You can easily switch between continuous paper with a rear push tractor and single sheets without
removing the continuous paper from the tractor.
Switching to single sheets
Follow these steps to switch from continuous paper from a push tractor to single sheets:
FX-890II/FX-890IIN/FX-2190II/FX-2190IIN User’s Guide
Paper Handling
53
