Epson Equity IIe, User Manual

Page: 142 / 276

Adding Memory Modules
The standard Equity IIe system comes with 1MB of on-board
memory. You can add SIMMs (single inline memory modules)
to increase the amount of on-board memory in the computer.
With added SIMMs, the total amount of on-board memory in
your computer must be one of the following: 2MB, 3MB, or
5MB.
There are four SIMM sockets inside the Equity IIe. Each socket
can contain one 256KB or one 1MB SIMM. The following
table shows the possible SIMM configurations for the Equity IIe.
Possible Equity Ile SIMM configurations
Total on-board Socket 1 Socket 2 Socket 3 Socket 4
memory
1MB
2MB 256KB 256KB 256KB 256KB
3MB 1MB 1MB
5MB 1MB
1MB
1MB 1MB
After SIMMs have been installed in your computer, you need to
run the Setup program on your Reference diskette to set the
computer’s on-board memory configuration, as described in
Chapter 2. Also see “Post-installation Setup,” later in this
chapter.
N o t e
If you
want to use extended memory as expanded memory,
you can use the EEMM286.SYS utility. See "Using Memory
Beyond 640KB" in Chapter 4 and your MS-DOS Reference
Manual for more information,
5-2 Installing Options