Epson EQUITY II+, User Manual

Page: 55 / 151

Appendix A
Jumper Settings
This appendix describes how to set the jumpers inside the Equity II+ if
you install optional devices that require different jumper settings in the main
unit. It is best if your dealer installs the option and makes all the necessary
adjustments when you buy it. If you decide to do it yourself, be very careful
when you follow the procedures in this appendix. There are many system
components that can be damaged accidentally
The Equity II+ jumpers you may need to change are on the:
l
Main circuit board
l
Memory card
l
Multifunction card (parallel port, serial port, and floppy disk controller).
Figure A-l shows where each of these cards is located in the computer.
Multi-function card
Memory card
Main circuit board
Figure A-1. Location of cards
User’s Guide
A-1