Epson EPL-N3000, Reference Manual

Page: 378 / 443

Functions of the Control Panel
365
B
B
B
B
B
B
B
B
B
B
B
B
GL2 Menu
This menu lets you set the printer to emulate a plotter, allowing
you to use software which requires a plotter for output. The
LJ4GL2 mode is similar to the GL/2 mode supported in the HP
LaserJet 4 mode. The GLlike mode emulates some of the HP-GL
plotter commands and includes all the commands found in HP’s
GL/2 mode, as well as two additional commands.
* Available only when
GLlike
is selected as the GL Mode.
Before you start printing in the GL/2 mode
You may need to change the following print options in your
application, depending on your output needs. Check these
settings to make sure they match the data you are trying to print.
Item Settings (default in bold)
GL Mode LJ4GL2 , GLlike
Scale Off , A0, A1, A2, A3
Origin Corner , Center
Pen Pen0 , Pen1, Pen2*, Pen3*, Pen4*, Pen5*,
Pen6*
End Butt , Square, Triangular, Round
Join Mitered , Miteredbeveled, Triangular, Round,
Beveled, None
Pen 0 through 6 0.05 ... 0.35 ... 5.00 mm in 0.05-mm increments
Print Options Settings
Paper size Printer’s paper size setting
Driver (plotter selection) HP-GL/2 or HP-GL
Pen configuration Pen thickness
Plot origin Center or Corner