Epson EPL-7000, User Manual

Page: 260 / 330

The Memory Chip Set
The memory chip set contains four
256
Kbyte chips that can be
installed on the printer’s controller board. Each memory chip set
increases the memory available to your printer by
0.5
MB
increments.
The memory chip set is available from your dealer or from Epson
Accessories at
1-800-873-7766.
If you wish, you can simply buy four
256K X 480
ns DRAM
(20-pin DIP) chips and install
them
according to the instructions in
this section.
Removing the controller board
To remove the controller board you need a cross-head screwdriver,
WARNING: High voltages are present inside the printer
when the power is on. Do not attempt to remove the
controller board unless the printer is turned off and the
power cord is unplugged. Also, try not to touch any
contacts on the circuit board of the printer because many
of the components can be destroyed by the static
electricity in your body.
1.
Unplug the power cable from
the
electrical outlet and
disconnect it from
the
rear of the printer.
2. Disconnect all interface cables from the rear of printer.
A-32 Appendix A