Epson EPL-6000, User Manual

Page: 71 / 219

Using SelecType
Initializing SelecType to factory default settings
To initialize SelecType options, returning them to the factory
settings, follow the steps below. (Factory settings are marked with
an asterisk (*) in the SelecType Options section.)
1.
2.
3.
4.
5.
6.
7.
Press
the ON LINE
button to set the printer off line.
Press the
SelecType
button to enter SelecType. This message
appears:
PAPER SIZE = LTR*
Hold down the
RESET/CONTINUE
button for three seconds until
the
message
INITIALIZE
appears in the display.
Your printer is
set
off line. This
message
appears in the display:
OFF LINE LTR
Hold down the
RESET/CONTINUE
button for three more seconds
until the message
RESET
appears in the display.
Your printer is set on line. This message appears in the display:
ON LINE LTR
If initializing SelecType changes your
DATA BUFFER, OVER
LOAD,
or interface submenu settings, you should also turn off the
power to save these settings. (Remember to wait for at least five
seconds before turning the printer back on.)
3-18
Using the Printer