Epson EPL-6000, User Manual

Page: 70 / 219

Using SelecType
7. Press the
SET
button to activate the option. The function stops
blinking, and the option starts blinking.
8. Use the or button to move to the option you want to set.
9. Press the
SET
button. An asterisk (*) appears next to the option,
indicating that the new option has been set. The option stops
blinking and the function starts blinking.
10. To exit
the
emulation submenu and return to the main menu,
use the or button to take you back to the main menu. The
message
I/F
=
SERIAL*
appears in the display.
If you wish to exit SelecType at
this
point, see the section below on
exiting SelecType.
Exit SelecType and reset the printer
To exit SelecType (from any main menu or submenu function) and
implement your changes, follow
these
steps:
1. When you have set all the options you want, press the
SelecType
button. The printer is set off line.
2. Hold down
the RESET/CONTINUE
button for three seconds (until
the
message
RESET
appears) to implement your changes. The
options are implemented in the printer’s memory until you
change them or initialize them to the factory settings.
Note:
To implement changes
to
the
DATA BUFFER, OVER
LOAD,
and interface submenu settings you
must also
turn
the
printer off. Remember to leave the printer off for at least five
seconds before turning it back on.
Using the Printer
3-17