45
4
Starting from the screen, press the cables into their respective channels in each track. Use a blunt tool, such
as a screwdriver handle, to press the cables into place. Press the smaller cables in first, and the large cable
last.
Note
The individual channels inside the track are sized differently. Be sure to place the correct cable in each channel. If
you’re unsure, check the colored dot at the end of the cable and match it to the color inside the track.
You may need a second person’s help to hold the cables while pressing them in the channels.
5
Press the covers in place on each track and connector piece. If necessary, use a hacksaw to cut the covers to
desired lengths.
Tip
When using a hacksaw, cut the plastic slowly to maintain smooth edges.
6
Apply a seam cover to disguise the seam where two pieces meet. Remove the adhesive backing from the
covers to apply them.
Connect the Cables to the Projector
1
Before connecting the cables to the projector, check to see if you have excess cable. If you do, wrap the
cable around the cleats above the projector, if you installed them (see page 39).
Caution
Do not tuck excess cable between the projector and the plate above the projector. This could block the air vent and
cause the projector to overheat.
Video cable
Speaker cable
Control cable
AC cable
Summary of Contents for Ensemble HD
Page 1: ...Installation Guide ...
