38
Making Detailed Adjustments
■
Motion Detection (Home Cinema 8100 only)
This setting specifies how signals are converted to progressive signals. Select a lower
setting for slow-moving or still images (
S
) or select a higher number for video images
(
M
).
Note:
This setting can be used only when viewing composite video or S-Video signals, or 480i
or 576i, or 1080i signals input through the Component, HDMI 1, or HDMI 2 ports (see page 68).
■
Noise Reduction
Note:
This setting cannot be used when the Color Mode is set to x.v.Color (see page 29) or
with a signal input through the PC port.
This setting reduces flickering of analog images. You can select from 3 levels of noise
reduction.
■
Mosquito NR (Home Cinema 8500 UB only)
Note:
This setting cannot be used when the Color Mode is set to x.v.Color (see page 29) or
with a signal input through the PC port.
This setting reduces grainy noise that can appear around the edges of MPEG images. You
can select from 3 levels.
■
Block NR (Home Cinema 8500 UB only)
Note:
This setting cannot be used when the Color Mode is set to x.v.Color (see page 29) or
with a signal input through the PC port.
This setting reduces block noise that can appear when projecting MPEG images that have
been compressed at a low bit rate.
■
2-2 Pull-down (Home Cinema 8100 only)
Note:
This setting can be used only when viewing a 1080p/24Hz signal input through the
Component, HDMI1, or HDMI2 ports (see page 68). This setting cannot be used when the
Color Mode is set to x.v.Color (see page 29) or with a signal input through the PC port.
This setting allows you to select whether images are projected with 2-2 pulldown
detection or 2-3 pulldown detection. Select
On
for 2-2 pulldown detection.
Signal > Motion Detection
Signal > Advanced > Noise Reduction
Signal > Advanced > Mosquito NR
Signal > Advanced > Block NR
Signal > Advanced > 2-2 Pull-down
