As the program checks each track, it decreases the cylinder
numbers to zero. When the test is complete, the program
displays a report on the status of the disk, such as the following:
Analysis finished.
Count of tracks flagged bad
=
12
Count-of tracks with read, verify errors =
n
Count of good tracks
= nnnn
No
read, verify error was detected.
If the program finds
errors,
the screen displays a table of the
tracks that produced the errors. Then you see this message:
Press
ENTER
to
return
to
the
menu.
Check the information displayed. Then press
to return to
the Hard Disk Format Menu.
Exiting the Program
To leave the Hard Disk Format Menu, select
Exit.
You
see
the
operating system command prompt.
If you formatted the hard disk or ran the Destructive surface
analysis option, you must now prepare your hard disk for use
with your operating system. See your operating system manual
for instructions.
Formatting a Hard Disk
5 - 1 1
Summary of Contents for Endeavor
