Epson Endeavor 486I, User Manual

Page: 154 / 196

You see a diskette drive error when you start your computer.
Run the SETUP program and configure your system for the
correct type of diskette drive. Make sure the
Floppy
controller option in SETUP is enabled. See “Configuring
integrated peripherals” in Chapter 2 for more information.
The diskette drive is making loud or unusual noises.
Contact your Authorized EPSON Servicer or the EPSON
Connection.
Hard Disk Drive Problems
A newly installed hard disk drive is not working properly or
ifs performance is not what you expect.
Make sure you have installed the drive correctly and check all
cable connections. Also, check the jumper settings on your
drive.
If this is your only hard disk drive, make sure it is connected to
the primary IDE interface on the system board. If you have a
CD-ROM drive, make sure it is not connected to the same
interface as the hard disk drive.
If you are using MS-DOS and Windows 3.1, make sure the PCI
IDE driver is installed and loaded (see “Installing the PCI IDE
Drivers” in Chapter 2). Make sure your IDE device can take
advantage of the PCI IDE feature.
Some hard disk drives do not support the power management
features on your system. You may need to disable these
features in SETUP. See “Using the Green PC Features” in
Chapter 2 for more information.
7-10 Troubleshooting