Epson EMP-TS10, User Manual

Page: 10 / 72

Turning On the Projector
8
••••
If only one signal source has been connected, the signals from that source will be
projected without needing to press one of the buttons from the previous table.
••••
If the "No-Signal." message does not disappear, check the connections again.
••••
If a laptop computer or a computer with an LCD screen has been connected to the
projector, the images may not be projected straight away. After making the connections,
check that the computer has been set up to output signals.
The following table shows examples of how to toggle output settings. For details, refer to
the section of the documentation provided with your computer under a heading such as
"External output", "Connecting an external monitor" or similar.
NEC Panasonic Toshiba IBM Sony Fujitsu Macintosh
[Fn]+[F3] [Fn]+[F3] [Fn]+[F5] [Fn]+[F7] [Fn]+[F7] [Fn]+[F10]
After startup, change the
Control Panel adjustments
so that Mirroring is active.
Connecting the Power Cord
Turning On the Power and Projecting Images