130
Maintenance
Maintenance
Select "Reset Lamp Timer" from the "About" menu
and then press the [Enter] button on the remote
control or the [Auto/Enter] button on the projector's
control panel.
Select "Yes" and then press the [Enter] button on the
remote control or the [Auto/Enter] button on the
projector's control panel.
The lamp operating time will then be reset.
The air filters can be replaced even if the projector is installed on a ceiling.
PROCEDURE
Turn the projector's power off, wait for the
period to end, and then disconnect the power
cable.
The cool-down period lasts for about 30 seconds.
2
Frequency
Source
V ---.--Hz
Reset Lamp Timer
H ---.--kHz
Lamp
1900H
SYNC Mode
SYNC Polarity
------
H ------
Resolution
Refresh Rate
0.0 Hz
0x 0
Computer
Input Signal
Analog-RGB
Execute
:
:
:
:
:
:
V ------
:
:
:
:
:
3
Reset Lamp Timer
Execute?
YES
NO
Reset Lamp Timer
Execute?
YES
NO
Replacing the Air Filters
1
Summary of Contents for EMP 7800
Page 1: ......